Verification Phase
Verification is where you prove the design and the process before committing to production tooling. We produce verification builds on the intended process, measure them against the drawing, document the results and flag anything that needs attention before the money is spent.
Dateien hochladen — Angebot in 24 Std. DFM-Prüfung anfordern
Was wir tun
Verification builds on intended production process
Verification builds on intended production process
Dimensional reports against ballooned drawings
Dimensional reports against ballooned drawings
Material and process certificates
Material and process certificates for the batch
Functional, leak and life testing coordination
Functional, leak and life testing coordination
CPK studies on critical dimensions
CPK studies on critical dimensions
Documented corrective action loop before release
Documented corrective action loop before release
Wichtigste Spezifikationen
| Spezifikation | Details |
|---|---|
| Sample stages | T1, T2 and pre-production |
| Inspection | CMM with full report |
| Documentation | FAI, dimensional report, material certs |
| Capability | CPK studies on request |
| Timeline | 5–15 working days per sample stage |
| Sign-off | Written release before mass production |
Häufige Fragen
What is the difference between T1 and T2 samples?
T1 is the first article from a new tool, used to identify tool corrections. T2 follows those corrections and is normally the sample used for customer approval and pilot builds.
Can you supply samples with production tooling steel?
Yes. Where a customer requires full production-intent samples we cut the production tool first and sample from it, which lengthens the schedule but removes the risk of the pilot-to-production gap.
What happens if dimensions are out of tolerance?
We issue a non-conformance report with the measured deviation, propose the tool change and re-sample after correction, all documented against the drawing revision.
More in this section
Design Services
Design for manufacturing review and engineering support: DFM analysis, material selection, tolerance optimisation and cost reduction before tooling.
Packaging & Kitting
Production packaging, kitting and labelling: retail cartons, foam inserts, barcode labelling and drop-tested transport packaging.
Mass Production
Mass production ramp and repeat supply: moulding, casting and machining at volume with process control, scheduled deliveries and stock holding.
Bereit, Ihr {service}-Projekt zu starten?
Senden Sie heute Ihre Dateien — DFM-geprüftes Angebot innerhalb von 24 Stunden.